Valve Performance

SKU: C-402Duration: 11 Minutes

Pay-per-view (PPV) format perfect for individual users.

Get immediate access to this interactive eLearning course online. Must be used within 30 days, expires 48 hours after launch.

Language:

\$19

Ideal for corporate licensing and high volume users.

Course Details

Specs

Training Time: 11 minutes

Compatibility: Desktop, Tablet, Phone

Based on: Industry Standards and Best Practices

Languages: English, Portuguese

You may know how valves work, but do you know how to select the right valve for the job based on its performance characteristics? If not, this is the course you've been looking for. Learn all the basic concepts and terms for evaluating a valve, including those for the amount of fluid that can flow through a given valve in a period of time, the distance the valve stem travels from the open to closed position and the relationship between the valve travel distance and the corresponding changes in flow rate. You'll also discover how the performance of a valve can change after it's installed in a real system with varying conditions, how well a valve can withstand pressure and prevent leakage, and how control systems can be used to increase the efficiency of valves.

Learning Objectives

• Describe valve coefficient
• Differentiate between linear, equal percentage, and quick-open flow characteristics
• Describe how valve stroke affects flow characteristics
• Differentiate between inherent and installed flow characteristics
• Describe pressure and shutoff classes
• Differentiate between feedback and feedforward control loops
• Describe rangeability

Key Questions

The following key questions are answered in this module:

What is the valve coefficient?
The valve coefficient is a measure of how much fluid can flow through a valve in a given time period.

What is the valve stroke?
The valve stroke is the distance the stem must move to go from fully closed to fully open.

What is the flow characteristic?
The flow characteristic describes the relationship between the stem's movement through its stroke and the corresponding changes to the valve's flow rate.

What are valve pressure classes?
Every valve can handle a certain amount of internal pressure. This is the valve's pressure rating. Valves can be classified by how much pressure they can handle. The most commonly used standards for valve pressure classes are set by the American National Standards Institute (ANSI). There are six standard pressure classes and additional special classifications and intermediate classifications.

What are valve shutoff classes?
Valves are also rated by the amount of leakage they permit when sealed. This leakage is measured as a percentage of the valve's rated flow capacity. ANSI has created six shutoff classes, with Class I being the weakest seal and Class VI the strongest.

What are actuator-controlled valves?
Valves that are not controlled by a manual operator, such as a lever or handwheel. Instead, actuator-controlled valves are controlled by an automatic actuator. Automatic actuators are frequently a part of a control loop that also includes a sensor and a controller.

What are control loops?
In a feedback control loop, the sensor monitors downstream conditions and sends that information to the controller. This then controls the valve. There are feedforward and feedback control loops.

Whtat is rangeability?
Rangeability is a measure of how effectively an automatic control valve can control a flow after receiving a signal from the controller. It is defined as the ratio of the maximum controllable flow divided by the minimum controllable flow through a valve.

Sample Video Transcript

Below is a transcript of the video sample provided for this module:

It is important to properly match the valve coefficient to a valve's intended use in a system. If the valve coefficient is too small, not enough fluid will pass through the valve and upstream equipment, such as pumps, can be damaged. If the valve coefficient is too large, the following problems could occur. The valve may be more expensive, larger, or heavier than necessary. The valve or pipes may be damaged as a result of too much flow, or the valve may experience the "bathtub stopper" effect. This occurs when the valve is near its closed position and is rapidly sucked closed, sending damaging waves through the system.